The R-121L gives you all the benefits of its sibling, the R-121, but is extra rugged to handle the demands of touring (as well as the most chaotic studio). Its 4-micron aluminum ribbon, as sensitive, yet tough as any aspiring Brando, ensures stellar performance no matter how rough the going.

Featuring a traditional figure-8 pattern with a warm, realistic tone and flat frequency response, it can handle the high SPLs (135 dB maximum) with ease.

Main Features:
• Extra-hardy, very sensitive 4-micron aluminum ribbon element
• High SPL Capabilities
• No internal active electronics to overload or produce distortion up to maximum SPL rating
• Extremely low residual noise
• Ribbon element is not affected by heat or humidity
• No high frequency phase distortion
• Equal sensitivity from front or back of element
• Consistent frequency response regardless of distance
• Mic clip included, but Royer highly recommends the optional AT84 shockmount to make the most of your microphone

Specifications:
• Acoustic Operating Principle: Electrodynamic pressure gradient
• Polar Pattern: Figure-8
• Generating Element: 4-micron aluminum ribbon
• Magnets: Rare Earth Neodymium
• Frequency Response: 30 -15,000 Hz +/- 3dB
• Sensitivity: -50 dBv Re. 1v/pa
• Output Impedance: 300 Ohms @ 1K (nominal)
• Rated Load Impedance: >1500 Ohms @ 300 Ohms
• Maximum SPL: >135dB @ 20 Hz
• Output Connector: Male XLR 3 pin (Pin 2 Hot)
• Dimensions: 58mm L, 25mm W (6.13" L, 1" W)
• Weight: 244g (8.6 oz)
• Finish: Dull Satin Nickel