NOTABOTYET TALLY-HELPER-100
Bookmark and Share

NOTABOTYET TALLY-HELPER-100


Interface for Yellowtec Mika Boom Talley Lights - Y16-M10-1

BSW PART: TALLY-HELPER-100

TALLY_HELPER_100.JPGIn Stock
Enter the Tally Helper 100. While it does not solve all of life’s problems, when installing Mika mic booms, it comes pretty darn close! Imagine having a nice clean phoenix-type screw terminal strip sitting there just waiting to have those 5 wires form the Mika mic boom locked down for a good, tight electrical connection. Imagine those same terminals having room for a microphone audio cable to loop out on its way to a favorite console or mic preamplifier. Imagine having a power supply that plugs into the device and provide a solid 12 volts of regulated power. Imagine an easy RJ-45 connector waiting to be plugged into an Axia GPIO port or Wheatnet Logic port or any standard GPIO type output that provides a closure to ground to activate. Imagine being able to decide which GPIO input bit will trigger the red tally and which will trigger the white tally. That is quite an imagination, but actually it is all real and ready to help.

Main Features:
• Phoenix-type screw terminal strip for both the Mika mic boom connections and the loop-thru connection to mic preamp.
• Included 12V regulated switching power supply.
• RJ-45 input connector with pinouts matching our Axia GPIO Breakout Board (Part# A15-B01-2) or Wheatnet IP logic ports.
• Active low inputs mean installers can any standard GPIO source (using open collector type closures to ground or relay closures to ground) to control the device
• Programmable jumpers allowing installer to determine which GPIO bit will trigger the Red tally and which bit will trigger White tally.
• Small device (no larger than a surface mount phone jack) can be mounted discreetly near the Mika mic boom.

List Price: $110.00
$94.00
In Stock
You Saved:
$16.00 (15%)


View ALL NOTABOTYET Products

Customers also Viewed...
Recently Viewed