Bing ads convertion tracker Ashly PEMA8250
Bookmark and Share

Ashly PEMA8250

Network Power Amp 8 x 250W at 4 Ohms with 8x8 Protea DSP


In many system installations, you can replace an entire rack of pro audio gear—with a single Pema™. Pema™ with it’s new sleek look, is a Protea-Equipped Media Amplifier—either 4 or 8-channel at 250 Watts or 125 Watts per channel. Pema is a matrix mixer—all Pema models have a full 8-in x 8-out matrix mixer, where any input can be assigned to any output or outputs. Pema is a digital signal processor. In addition to the full Protea™ suite of DSP settings, we have added four new features to Pema—gain sharing automatic microphone mixing, an automatic feedback suppressor, ambient noise detection and adjustment and a real-time clock with an event scheduler. Pema features Ashly’s energy efficient Class-D amplifier topology with a switching power supply—and is over 80% energy efficient out of the box. Maximize the energy efficiency of your audio system by using the event scheduler to either put the Pema in stand-by mode or turn it off completely. Pema is offered in separate Low-Z, 25V, 70V, or 100V constant voltage models. Pema is also offered with 240V line voltage in either Low-Z or 100V output for International customers.

Main Features:
• CobraNet® and Dante® network audio fully supported
• FIR Filter capable
• 8-in x 8-out sophisticated matrix mixing
• 8 built-in mic pre’s
• Gain sharing automatic microphone mixing (Automixer)
• Automatic feedback suppression
• Ambient noise compensation
• Dedicated telephone/PBX input
• Dual RCA and balanced euroblock inputs
• Post DSP AUX line level outputs
• Stereo summed to mono
• Event scheduling (RTC)
• Adjustable HP/LP filters
• Built-in pink/white noise & sine wave generator
• Full suite of Ashly Protea™ DSP
• Hot-plug DSP placement
• 96kHz or 48kHz sample rate
• 32-Bit SHARC DSP
• 24-Bit A/D–D/A audio resolution
• 15V phantom power for mic inputs
• Full control using Ashly software over 10/100 baseT Ethernet
• Easy and intuitive user interface
• Automatic DHCP network IP configuration
• Euroblock connectors for preset recall, DC remote level control and serial data control
• External control via Ashly standard wall remotes, Ashly Ethernet wall remotes or Ashly Remote iPad® App
• Level control via variable DC control voltage
• Stand-By mode activation via contact closure
• Multi-level Security
• Safety/Compliance: cTUVus, CE, FCC, RoHS

• Input Sensitivity (Low Z models): 3.2dBu (4125/8125) 6.2dBu (4250/8250) 7.2dBu (70V/100V models)
• Voltage Gain: 26dB (Low Z models), 32dB (70V models) 35dB (100V models)
• Damping Factor: >250 (8 Ohm load, <1kHz)
 • <0.5% (SMPTE, typical)
 • <0.5% (THD-N, typical, 8 Ohm, 10dB below rated power, 20Hz–20kHz)
• Channel Separation: -80dB (dB from full output, 1kHz)
• Frequency Response: 20Hz–20kHz, +/-1dB
• Mic/Line Input Impedance: 4.8k Ohms
• Mic/Line Maximum Input Level: +21dBu
• Mic/Line Preamp Gain: 0, +20dB, +40dB, +60dB
• Mic/Line Phantom Power: +15V, switchable ch. 1-4, 5-8
Summed Mono:
 • 3.16k Ohm (Input Impedance)
 • +11dBu (Maximum Input Level)
Channel 1 TEL-PBX:
 • 3.9k Ohm (Input Impedance)
 • +21dBu (Maximum Input Level)
• Preamp Output Maximum Level: +8dBu
• AUX Output Maximum Level: +20dBu
• Environmental: 40-120 deg. F, (4-49 deg, C) (noncondensing)
Audio Connections:
 • 1 Euro connector balanced input, selectable for Mic, Line or TEL-PBX
 • 7 Euro connector balanced inputs, software selectable for Mic or Line
 • 8 pairs of unbalanced, summed mono RCA connectors optimized for consumer line level (-10dBV nominal) devices
 • 8 Euro connector Preamp/Aux outputs
 • 4 or 8 Euro connector speaker outputs
 • CobraNet® and Dante® Digital I/O options
Power Requirements:
• AC Mains: 120VAC or 240VAC, ±10% 50–60Hz
• Power Cable Connector: 15A Edison, 3-Prong IEC
Weights and Dimensions:
• Dimensions: 19” W x 3.50” H x 16.84” D (483mm x 89mm x 428mm)
• Airflow: IN through sides, OUT through front
Unit Weight:
 • 4125/4250: 23.5 lbs (10.7 kg)
 • 8125/8250: 25 lbs (11.3 kg)
Shipping Weight:
 • 4125/4250: 30.9 lbs (14 kg)
 • 8125/8250: 32.3 lbs (14.7 kg)
• Environmental: 40-120 deg. F, (4-49 deg, C) (noncondensing)

List Price: $5,249.00
Free Shipping!
Call For Availability
You Saved:
$1,050.00 (20%)

View ALL Ashly Products