Rolls RA200

The Rolls RA200 power amplifier features two 100 watt RMS - 4 ohm outputs, a bridging switch, MOSFET drivers in a voltage and current gain circuit, one second power-up delay, and LED power output meters. The unit is housed in a painted steel chassis and includes a special high performance transformer, and a fused power line. The MOSFET output stage is fault protected which allows the RA200 to forgive momentary output shorts, and has over-temperature protection.

The RA200 is convection cooled. Adequate ventilation room for the heat sink fins on the rear panel must be provided.

Rolls RA200 Specifications:
• Power Output, stereo: 100 Watts RMS/ch. 4 ohms, 70 Watts RMS/ch. 8 ohms; bridged: 200 Watts RMS, 8 ohms
• Input Connectors: 1/4" TRS balanced and RCA
• Output Connectors: Binding posts
• Sensitivity: <1 VRMS for full output
• THD: <.08% (1kHz @ 1 Watt)
• S/N Ratio: 106 dBU
• Power Bandwidth: DC - 30 kHz +/- 1dB
• Damping Factor: > 150
• Slew Rate: 100 Volts/microSecond
• Phase Shift: <10 Deg., 20Hz - 20kHz
• Input Impedance: 10 K ohms Balanced
• Power: 120 VAC 60Hz 2.5A, 230 VAC 50Hz
• Size: 19" x 3.5" x 7.5" (48 x 9 x 19 cm)
• Weight: 12 lbs (5.5 kg)