­

Lectrosonics WM-23

LECTROSON

BSW PART:
WM-23

Water Tight Transmitter, Variable RF Power, with mic, Block 23 (588.800 - 614.300 MHz)

Contact BSW for your pricing and shipping!

Contact BSW for your pricing and shipping!

Free Shipping

Out of stock

Add to quote
Qualifies for free shipping
  • Main Features:
  • Selectable output power to maximize battery life or operating range
  • Machined aluminum, corrosion resistant housing
  • Water resistant seals for use in wet environments
  • LCD interface with lockout option
  • Programmable compatibility modes for use with a wide variety of different receivers
  • Servo Bias input circuitry with selectable voltage
  • Specifications:
  • Channel Spacing: 100 kHz
  • Frequency selection: Control panel mounted membrane switches
  • RF Power output: Switchable; 50, 100 or 250 mW
  • Compatibility Modes (6) Digital Hybrid Wireless® (400 Series), 200 Series, 100 Series, Mode 3, Mode 6, IFB
  • Pilot tone: 25 to 32 kHz; 5 kHz deviation (in 400 Series Hybrid Mode)
  • Frequency stability: ± 0.002%
  • Deviation: ± 75 kHz max. (in 400 Series Mode)
  • Spurious radiation: 60 dB below carrier
  • Equivalent input noise: –125 dBV, A-weighted
  • Input level:
  • Dynamic mic: 0.5 mV to 50 mV before limiting. Greater than 1 V with limiting.
  • Electret lavaliere mic: 1.7 uA to 170 uA before limiting. Greater than 5000 uA (5 mA) with limiting.
  • Line level input: 17 mV to 1.7 V before limiting. Greater than 5 V with limiting.
  • Input impedance:
  • Dynamic mic: 300 Ohms
  • Electret lavaliere: Input is virtual ground with servo adjusted constant current bias
  • Line level: > 2.7 k Ohms
  • Input limiter: Soft limiter, 30 dB range
  • Bias voltages: Selectable; 2V, 4V and Off
  • Gain control range: 44 dB; panel mounted membrane switches
  • Modulation indicators: Dual bicolor LEDs indicate modulation of –20, -10, 0, +10 dB referenced to full modulation
  • Controls: Control panel with LCD and four membrane switches